The standard incorporates performance requirements which allow employers flexibility in developing lockout/tagout programs suitable for their particular facilities.ġ. The lockout/tagout provisions of this standard are for the protection of general industry workers while performing servicing and maintenance functions and augment the safeguards specified at Subparts O, S, and other applicable portions of. The new rule addresses practices and procedures that are necessary to disable machinery or equipment and to prevent the release of potentially hazardous energy while maintenance and servicing activities are being performed.ģ. Such violations reached a level so significant that the development and promulgation of a lockout/tagout standard was required.Ģ. Since the inception of its enforcement program, OSHA has relied on the "General Duty Clause" (Section 5(a)(1) of the OSH Act) to ensure that employers safeguarded their maintenance and service employees through the use of lockout/tagout from the hazards involving the unintentional release of hazardous energy. 169 (pages 36644-36696), and was effective on January 2, 1990, as announced at Federal Register, Volume 54, No. 147, was promulgated on September 1, 1989, at Federal Register, Volume 54, No. The Standard for Control of Hazardous Energy (Lockout/Tagout). Review policies, instructions and guidelines issued by the State to determine that this change has been communicated to State personnel. The Regional Administrator shall provide a judgment on the relative effectiveness of each substantial difference in the State plan change and an overall assessment thereof with a recommendation for approval or disapproval by the Assistant Secretary.ĥ. After Regional review of the State plan supplement and resolution of any comments thereon, forward the State submission to the National Office in accordance with established procedures. If the State adopts an alternative to Federal guidelines, the State's submission must identify and provide a rationale for all substantial differences from Federal guidelines in order for OSHA to judge whether a different State guideline is as effective as a comparable Federal guideline.Ĥ. Any alternative State inspection guidelines must be submitted as a State plan supplement within 6 months. The State's acknowledgment letter may fulfill the plan supplement requirement if the appropriate documentation is provided.ī. If a State intends to follow the revised inspection guidelines described in this instruction, the State must submit either a revised version of this instruction, adapted as appropriate to reference State law, regulations and administrative structure, or a cover sheet describing how references in this instruction correspond to the State's structure. This acknowledgment should include the State's intention to follow the inspection guidelines described in this instruction, or a description of the State's alternative guidelines which are "at least as effective" as the Federal guidelines.Ī. Ensure that State designees acknowledge receipt of this Federal program change in writing, within 30 days of notification, to the Regional Administrator. ![]() Explain the technical content of this change to the State designee as requested.ģ. Ensure that this change is forwarded to each State designee.Ģ. This instruction describes a Federal program change which affects State programs. Regional Administrators and Area Directors shall ensure that the guidelines and interpretive guidance in this instruction are followed and that compliance officers are familiar with the contents of the standard.į. The information collection requirements contained in this section have been approved by the Office of Management and Budget (OMB) and listed under OMB control number 1218-0150, as announced at Federal Register, Volume 54, No. 147 have an effective date of January 2, 1990. OSHA Instruction CPL 2.45B, June 15, 1989, the Revised Field Operations Manual (FOM).ĭ. General Industry Standards,, Subpart O, Subpart S, and other specific subparts.Ģ. This instruction establishes policies and provides clarification to ensure uniform enforcement of the Lockout/Tagout Standards.ī. 147, the Control of Hazardous Energy (Lockout/Tagout)-Inspection Procedures and Interpretive GuidanceĪ. ![]() OSHA Instruction STD 1-7.3 Directorate of Compliance Programs Department of Labor Assistant Secretary for
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |